Since my sister asked me to be one of the bridesmaids at her wedding next month, I’ve been pondering what to
wear sew. I’ve finally settled on the Sew Over It Betty dress – a full-skirted knee-length dress with a straightforward sleeveless bodice, designed to be sewn in lightweight woven fabric like cotton lawn.
I like the neckline (front and back) on this dress, and once I get it to fit, I’m hoping I can hack this pattern around to make a few variations later. Lisa Comfort has dozens, apparently!
So task number one was to toile the bodice to make sure I could get it to fit. My measurements are currently 39-32-43, so I started by sewing the size 14 with no alterations. Here’s how that looked…
From the front, you can see there’s some puffiness in the front bra strap area, between bust and shoulder. The neckline is sitting quite wide on the shoulders, and it’s obviously too short – take off 1.5cm from the bottom edge and I’m suddenly wearing a crop top rather than something that lands at my waist. On the up side, the bust darts are almost exactly in the right place, so I won’t need to move those.
From the back, again it’s too short; the back looks slightly too broad overall at bust level – a sign that my ‘girls’ are dragging the back piece fowrards; and there’s more sagging at the sides of the upper chest area.
From the side, you can see the side seam is bowing forwards at bust level, but the armscye looks more or less OK, other than the puffiness at the upper chest.
(I’m sorry these photos are a bit grainy – the lighting wasn’t ideal yesterday and I’m still learning how to deal with that.)
Looking at these pictures, I decided to make three changes:
- Go down to a size 12, grading out to a 14 at the waist
- Add 1″ to the length
- Do a full bust adjustment to increase the circumference at the bust back up to the same as the size 14
There’s no lengthen/shorten line marked on the pattern, so I drew my own – about 1″ above the natural waistline (also not marked – grrrr…), perpendicular to the grainline. At this point I also made a note on the envelope to buy a longer zip than it says in the instructions.
For the FBA, I used this excellent tutorial from Mary at Idle Fancy. There are lots of FBA tutorials around, but this one has a kind of all-in-one method so you don’t have to trace off the pattern multiple times. And Mary also reminds you that for a larger bust, you may want to position the dart points further away than the standard 1″ that works well for a B cup.
This time around I also trimmed off the seam allowance on the front and back neckline, and around the armhole to get a better idea of where these would sit on me. Toile number 2 looked like this:
I’m almost happy with this. The length and bust fit well, with fewer draglines pointing to the bust. The only area that’s not working is the upper back at the sides. This could be a couple of things – I usually need a swayback adjustment, but I don’t think that’s the only thing.
In the past, I’ve made narrow back adjustments, but looking at this, I’m wondering if I need a sloping shoulder adjustment.
Or do you think it could be something else?