So the Astoria is possibly the second most popular sweatshirt pattern in the sewisphere, after the Linden. It’s definitely less sculptural than the Talvikki, but I really wanted a workhorse, fitted sweatshirt with a set-in sleeve, so this was the pattern for me.
The sample images for this Seamwork pattern are gorgeous in sweater knit, but I also really love Rachel’s scuba version. To make it up, I used some pale pink flecked sweatshirting I’ve been hoarding for almost a year. It’s soooo snuggly. I realised afterwards that I must have subconsciously copied Lauren’s version!
Fit and fiddle
My back waist measurement is 17.5″ so I added two inches to the length so that the hem band seam would fall at my natural waist. For me, this is more wearable than the original cropped length (I have a small child – I can’t go a whole day without bending over or reaching up). I also added 1cm to the sleeve length, but ended up cutting this off again.
Size wise, I was hovering between the M and the L, and ended up making the M but grading it out to an L from the armpits down to the waist. It’s ended up a little too tight at the bust and on the arms. This is the first pattern ever to decree I have fat arms, so I’m sulking a bit about that. The fit is good across the back, but I can’t really assess the fit at the armscye properly because my bust is dragging the whole thing forwards. My full bust point is usually on the high side, so perhaps I should have cut the L and then narrowed the shoulders and the neckline instead – but then potentially ended up with an oversized armhole? Or cut the M, but added an FBA, graded out to the waist and added width to the sleeve? I don’t know which would have been the best solution on this one.. . Any advice?
Seamwork says that this pattern sews up in under an hour. Perhaps. If you don’t count cutting and sticking together the pattern, cutting out, faffing with a twin needle or umming and ahhing over any fitting alterations. I’d say the whole thing actually took me three hours.
The instructions are clear and easy to follow with links to helpful posts on Colette’s blog if you need more help. The sleeves are set in flat, so it’s easy to do all the main seams on an overlocker/serger.
I had a few issues with my overlocker (more on that another time), so I couldn’t use it to attach the neckband or the hem band. In this fabric, I found the neckband was too long and stood up when I basted it in, so I unpicked it, trimmed it by 2cm (1cm on the folded pattern piece) and it was much better second time around.
I opted for the full-length sleeves, figuring I could always cut them off to 3/4 length if I changed my mind later. The sleeve circumference at the wrist is a tiny 17cm, and although it goes over my hand it wouldn’t go around the free arm on my sewing machine. This made hemming the sleeves with the twin needle a nightmare. In the end I turned the sleeve inside out and did it from the inside, as I’d normally set in a sleeve, but because the cuffs are so much smaller than an armhole this was close to impossible and the stitching isn’t very neat. How do people who make the size XS manage?!
That said, I love the fabric, and I figure the British weather isn’t often all that warm – even in summer – so I’ll get plenty of wear out of this. I love that it coordinates with my favourite wardrobe singleton, the green lace skirt in the picture. And I’m hoping to get round to a second version with an improved fit.